Testing the imported process

IE to Edge process conversion is performed and the automation process is imported to Automation Studio, then you can test the process.

 
To test the imported process:

1. Open the imported process.
   

   NOTE:

   In case, the status for import failed then, you are required to reconfigure the particular step in the automation process. For more information about the Automation process conversion, see Running IE to Edge Process Converter Utility.

2. If the converter fails to convert a specific step then, you must reconfigure that specific step or raise a support ticket when in case of logs do not help.
3. Save the process.
4. Setup the environment and perform a test run. For more information about setting up the environment and performing test runs, see AE-RPA-Engage-Automation Studio User Manual.